Overview - Rear Lid
- Rear Lid
- A second technician will be needed during removal and installation to support and to hold the rear lid.
- Removing: NOTE:
Mark the position of the rear lid on the rear lid hinge with a felt-tip pen before removing.
-- Remove the rear lid trim panel. Refer to Description and Operation .
-- Disconnect the electric wires on the connectors and pull them out of the rear lid.
-- Remove the nuts on the rear lid side and then remove the rear lid.
- Install in reverse order of removal.
- The springs -6- must be engaged before installing the rear lid.
- Adjusting:
-- Adjust the front height and the position of the hood lengthwise using the hood hinge.
-- Adjust the height of the back of the rear lid by adjusting the rear lid latch.
-- Align the hood so it is centered according to the gap dimensions. Refer to HOOD, ADJUSTING .
-- Adjusting buffer stops
- Rear Lid Seal, Removing and Installing. Refer to REAR LID SEAL, REPLACING .
- Stop Strip
- Adjusting Buffer
- Adjusting, refer to Adjusting the Rear Adjusting Buffer .
- Rear Lid Latch
- Removing and installing. Refer to REAR LID LATCH, REMOVING AND INSTALLING .
- Nut
- 21 Nm
- Spring
- Attachment points, refer to Spring Engaging Points .
- Rear Lid Hinge
- Removing and installing. Refer to REAR LID HINGE, REMOVING AND INSTALLING .
- Nut
- 21 Nm
- Bracket
- Nut
- 21 Nm
- Bolt
- 21 Nm
- Bolt
- 21 Nm
- Rear Lid Motor 1 - V444-
- Removing and installing. Refer to Rear Lid Motor 1 -V444-, REMOVING AND INSTALLING .
- Side Stop
- Removing and installing. Refer to SIDE STOP BUFFERS, REMOVING AND INSTALLING .