Lane Change Assistance, Preparing For Calibration

Special tools and workshop equipment required 

• Calibration ToolVAS 6350

Fig 1: Identifying Lane Change Assistance, Preparing For Calibration

Courtesy of AUDI OF AMERICA, LLC

1. Spacing Laser -VAS 6350/2-
   • For distance measurement
   • Refer to the operating instructions that come with the Calibration Tool -VAS 6350-
2. Calibration Tool -VAS 6350-
3. Water Level
   • On Calibration ToolVAS 6350
   • To check horizontal position of Calibration ToolVAS 6350
4. Catch Bracket
   • For mounting Spacing Laser -VAS 6350/2- for distance measurement
   • Distance to Wheel Center Sensor -VAS 6350/1- on rear wheels: Dimension -a- = 1700 ± 2 mm
5. Wheel Center Sensor -VAS 6350/1-
   • With wheel bolt adapter and measuring paddle
6. Brand Emblem
   • The laser point is aligned on the center of the brand emblem
7. Calibration Tool For Lane Change Assist -VAS 6350/4-
   • Is moved from one side of measuring field to the other during calibration
   • When installed correctly, vehicle electrical system voltage line must be connected at bottom left of calibration device (as seen in direction of travel)
8. Measurement Scale
   • For positioning Calibration Tool For Lane Change Assist -VAS 6350/4-
9. Line Laser -VAS 6350/3-
   • With Laser eye protection
   • On Calibration Tool -VAS 6350-
   • Turning on and off, refer to the operating instructions that come with the Calibration Tool -VAS 6350-
10. Plastic Foot
    • Quantity: 3
    • Adjustable in order to adjust horizontal position of Calibration Tool -VAS 6350-