Rear Axle Toe, Adjusting
Special Tools And Workshop Equipment Required
- Ring spanner insert AF 21:T40183
- No illustration, commercially available pawl with fine gear
-- Remove the nut -A- of threaded connection tie rod/subframe, and screw on new nut until stop.
-- Adjust toe by turning eccentric bolt -B-.
Wheel alignment specified values, refer to WHEEL ALIGNMENT SPECIFIED VALUES .
-- Tighten the nut -A- using the :T40183 (95 Nm).
-- After tightening nut -A-, check toe value once more. Refer to WHEEL ALIGNMENT SPECIFIED VALUES .
NOTE:
The maximum adjustment range is 90° to left or right of center position.
The geometric drive axle is automatically changed when individual toe settings are changed.