Triple Roller Joint AAR 2600 I Or 3300 I, Disassembling

Fig 1: Identifying Clamps & Protective Boot

Courtesy of AUDI OF AMERICA, LLC

-- Clamp drive axle horizontally in vise.

NOTE:

Use vice clamp jaw protectors.

Make sure that drive axle is not damaged.

-- Mark the location of the joint to the drive axle

NOTE:

If they are not marked and are not installed in their previously installed positions, noises may occur later during driving operation.

A water-proof felt pen is well-suited for marking.

-- Open clamps -arrows-.

-- Slide back protective boot.