Control Position, Programming

Special Tools And Workshop Equipment Required

Vehicle Diagnostic Tester

WARNING:

During A Test Drive, The Testing And Measuring Equipment Must Always Be Secured On The Back Seat.
These devices may be operated only by a passenger during a test drive.

-- Connect the Vehicle Diagnostic Tester

-- Switch on the Vehicle Diagnostic Tester.

The Vehicle Diagnostic Tester Is Ready For Operation When The Operating Modes Are Displayed.

-- Turn on the ignition.

Requirements

The vehicle must be standing on an even surface.
The vehicle may not be loaded.
The Electronic Damping Control Module -J250- must be coded.
The DTC memory may not contain any vehicle level sensor -- DTC memory entries.

NOTE:

If Control Modules Or Electric/Electronic Components Were Replaced, Then The Components Must Be Adapted Under "Guided Functions ".

-- Touch Guided Functions and the screen.

Then:

-- Select the corresponding program in "Guided Functions ".

-- Follow the prompts on the screen.

NOTE:

If The Control Position Was Programmed Again On Vehicles With Lane Assist, The Directional Stabilization Assistance Control Module -J759- With Integrated Camera Must Be Calibrated. Refer to LANE ASSIST, CALIBRATING .