Central Valve, Removing And Installing: Removing
The central valves are attached to the impact member under the bumper cover in the rear and on the left side.
-- Remove the rear bumper cover. Refer to REAR BUMPER .
WARNING:
Always wear safety goggles!
NOTE:
The DRC lines must be extracted before disconnecting them from the central valve. Refer to DYNAMIC RIDE CONTROL (DRC), SYSTEM DRAINING AND FILLING .
Perform this step on both wiring harnesses on the central valve.
-- Remove the DRC lines -5 and 6- or -9 and 10- depending on the central valve.
-- Remove the bolts -13- and the central valve.