Seat Side Trim On The Tunnel Side, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
- Follow all Safety Precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS WHEN WORKING WITH PYROTECHNIC COMPONENTS .
- Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.
-- Remove the front seat. Refer to FRONT SEAT, REMOVING AND INSTALLING .
-- Fasten the front seat on the :VAS6136 . Refer to FRONT SEAT, MOUNTING ON FIXTURE FOR SEAT REPAIR .
Standard Seat/Sport Seat/Super Sport Seat
-- Remove the expanding rivets -3 and 4-.
-- Disengage the tunnel-side trim -2- from the backrest hinge and remove it.
NOTE:
Make sure the tab -1- is not damaged when removing the trim.
Multi-Contour Seat
-- Remove the expanding rivet -1-.
-- Remove the bolt -3-.
-- Detach tunnel side trim -2- on the backrest hinge trim -arrow- and remove.