LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2014 >> A5 Prestige >> Repair and Diagnosis >> External Pages >> Different car >> Section 980 (Climate Control System (Service Information - (Front Heater & A/C Unit) CAEB, CGXB, CEUC, CTUA, CEUC, CAED, CHJA, CPNB, CRDB, CPNB, CREC, CTGE, CYNB, CWUC, CREH, CWUB)) >> Air Conditioning >> Front Heater And A/C Unit >> Fresh Air Blower -V2-, REMOVING AND INSTALLING >> Fresh Air Blower -V2- WITH Fresh Air Blower Control Module -J126-, REMOVING AND INSTALLING >> Removing

Fresh Air Blower -V2- WITH Fresh Air Blower Control Module -J126-, REMOVING AND INSTALLING: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Note the general information. Refer to GENERAL INFORMATION FOR ADJUSTMENT MOTORS .

-- Place the right front seat as far towards the rear as possible.

-- Turn off the ignition.

-- Remove the glove compartment. Refer to GLOVE COMPARTMENT, REMOVING AND INSTALLING .

-- Loosen the quick release -2- with a screwdriver -1-.

GWWA87-10988Courtesy of AUDI OF AMERICA, LLC

-- Detach the cover -3- from the bracket -4- and remove it.

-- Disconnect the connector -C-.

GWWA87-10693Courtesy of AUDI OF AMERICA, LLC
NOTE:

Press the locking mechanism down with a small screwdriver, for example, to release the connector.

-- Remove the bolts -A-.

WARNING:

There is a risk of burns.

  • If the Fresh Air Blower -V2- with the Fresh Air Blower Control Module -J126- was in operation before the removal, it may be hot.
  • Do not touch the hot radiating surface of the Fresh Air Blower Control Module -J126-.

-- Remove the fresh air blower -B- from the air intake housing -E-.

CAUTION:

Fan wheel imbalance.

  • Do not grasp fan wheel of the Fresh Air Blower -V2-, force against the fan wheel or shifting the balancing weights fastened to fan wheel may cause imbalance and then problems during operation.
NOTE:

Depending on the vehicle version (the thickness and version of the foam under the floor covering in the area of the fresh air blower), it is not always possible to remove the fresh air blower from the air intake housing and reinstall it without crushing the fan wheel. However, the fresh air blower can be damaged by even a brief application of force.

If it is not possible to remove the fresh air blower from the air intake housing and reinstall it without crushing the fan wheel, the air intake housing must be removed. Refer to AIR INTAKE MANIFOLD, REMOVING AND INSTALLING .

scientia non olet · About LEMON Manuals