LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2014 >> A5 Prestige >> Repair and Diagnosis >> External Pages >> Different car >> Section 977 (Airbags And Restraint Systems (Service Information)) >> Passenger Protection, Airbags, Seat Belts >> Seat Belts >> Front Seat Belt Latch, Removing And Installing >> Front Seat Belt Latch, Removing And Installing, Multi-Contour Seat >> Removing

Front Seat Belt Latch, Removing And Installing, Multi-Contour Seat: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Deactivating the front passenger airbag on vehicles with passenger occupant detection system:

  • Replace the passenger occupant detection system seat belt latch each time the passenger belt tensioner deploys.

-- Remove the front seat. Refer to FRONT SEAT, REMOVING AND INSTALLING .

-- Remove the trim on the tunnel side. Refer to SEAT SIDE TRIM ON THE TUNNEL SIDE, REMOVING AND INSTALLING .

-- Disconnect the connector -3- and free up the wire.

GWWA69-10524Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -2- and then remove the seat belt latch -1-.

scientia non olet · About LEMON Manuals