Front Passenger Airbag Unit With Igniter, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Follow all safety precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS WHEN WORKING WITH PYROTECHNIC COMPONENTS .
Before handling pyrotechnic components (for example, connecting a connector), the person handling it must "discharge static electricity". For example, this can be done by briefly touching the door striker.
Note the allocation of the airbag to the instrument panel. Refer to the Parts information.
Replace the connector for the Front Passenger Airbag Release Valve Igniter -N491- after an airbag has deployed. .

Install in reverse order of removal and note the following:

NOTE:

Make sure the connectors are installed all the way and engage audibly.

Make sure the wires do not get caught.

WARNING:

The ignition must be on when connecting the battery. If pyrotechnic components (for example, airbag, belt tensioner) are not repaired correctly, they may deploy unintentionally after connecting battery. There must not be anyone in the vehicle interior when connecting the battery.

CAUTION:

When working on vehicles with the ignition switched on or with ready mode activated, there is a risk of the engine starting unexpectedly and of gas poisoning in enclosed areas. Risk of body parts and/or clothing being pinched or pulled.

Perform the following before switching on the ignition:

Move the selector lever into P.
Activate the parking brake.
Turn off the ignition.
Open the hood
Connect the charger, such as the Battery Charger :VAS 5095A to the jump start point on the 12 V vehicle electrical system.
Switching on the ignition

-- Connect the battery ground cable with the ignition switched on. Refer to BATTERY .

NOTE:

If the Airbag Indicator Lamp -K75- indicates a fault after installing, check the DTC memory, erase it and check it again using the Vehicle Diagnostic Tester.