Crankshaft, Measuring Axial Clearance
WARNING: This page is about a different car, the 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Dial Gauge Holder :VW387
- Dial Gauge - 0-10mm :VAS6079
-- Install the :VAS6079 with the :VW387 on the cylinder block as shown in the illustration.
-- Place the dial gauge against the crankshaft counterweight.
-- Press the crankshaft against the dial gauge by hand and set the gauge to "0".
-- Press the crankshaft off the dial gauge and read the measurement.
Axial clearance:
- New: 0.09 to 0.25 mm.