Overview - Balance Shaft
WARNING: This page is about a different car, the 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 9 Nm
- Install with locking compound. For the correct locking compound. Refer to the Parts information.
- Gear Carrier
- Bolt
- 23 Nm
- Nut
- 30 Nm + 90° turn
- When loosening or tightening, use the Diesel Injection Pump Locking Pin :3359 as a counterhold tool.
- After loosening the nut, the balance shaft must be replaced
- Drive Chain Sprocket
- For the balance shaft
- Balance Weight
- Transmission side
- Roller Bearing
- Balance Shaft
- Removing and installing. Refer to BALANCE SHAFT, REMOVING AND INSTALLING .
- After loosening the nut -4-, the balance shaft must be replaced
- Bolt
- 60 Nm
- When loosening or tightening, use the :3359 as a counterhold tool.
- Balance Weight
- Belt pulley side
- Roller Bearing