Vacuum Pump, Turbo FSI 4-Cylinder: Installing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Replace the seal.

Make sure the seal is correctly installed.

-- Position the vacuum pump tappet so it engages in the groove on the camshaft when vacuum pump is installed.

-- Insert the vacuum pump.

-- Make sure the seal is seated correctly.

-- Install and tighten all the bolts -arrows- on the vacuum pump sealing flange, refer to -Item 1- 1.

Fig 1: Identifying Vacuum Pump Bolts Location

Courtesy of AUDI OF AMERICA, LLC

-- Push the new hose clamps over the vacuum hose.

-- Push the vacuum hose over the connection to the vacuum pump.

-- Compress the hose clamp on the vacuum pump connections with pliers.

CAUTION:

Do not damage the vacuum hose. Replace the vacuum hose if damaged.

-- Connect the wires to the high pressure pump and to the vacuum pump.

-- Connect the ignition coil connectors -arrow-.

Fig 2: Connecting Connectors To Ignition Coils

Courtesy of AUDI OF AMERICA, LLC

-- Install the ignition coil strip.

-- Install the fuel high pressure pump, refer to the appropriate service information .

-- Install the engine cover.