LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2014 >> A5 Prestige >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 (Hydraulic Components - Brake System (Coupe)) >> 47 Hydraulic Components >> Removal And Installation >> Vacuum Pump >> Brake System Vacuum Pump -V192-, RS 5 >> Removing

Brake System Vacuum Pump -V192-, RS 5: Removing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

The electric vacuum pump is located inside the engine compartment on the left side.

-- Raise the vehicle.

-- Remove left front wheel.

-- Remove the left front wheel housing liner, refer to OVERVIEW - FRONT WHEEL HOUSING LINER .

NOTE:

View brake system vacuum pump -- from underneath after removing the wheel housing liner.

Fig 1: Brake System Vacuum Pump -V192- Overview
GWWA47-10072Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -3- from the brake system vacuum pump --.

-- Remove the bolt from the bracket -2- for the brake system vacuum pump --.

-- Remove the secondary pump hose from the bracket for the brake system vacuum pump --.

-- Lower the vehicle.

NOTE:

View brake system vacuum pump -- inside the engine compartment, in the front on the left side.

Fig 2: Brake System Vacuum Pump Components
GWWA47-10071Courtesy of AUDI OF AMERICA, LLC

-- Remove the secondary pump hose from the bracket -4-.

-- Move the secondary pump hose to the side.

-- Remove the nut from the coolant pipe bracket.

-- Move the coolant pipe to the side.

-- Remove the two bolts from the bracket for the brake system vacuum pump -- -1 and 5-.

Fig 3: Brake System Vacuum Pump Components
GWWA47-10071Courtesy of AUDI OF AMERICA, LLC

-- Remove the vacuum hose for the brake system vacuum pump -- from the brackets inside the engine compartment.

CAUTION:

Be careful not to bend or damage the vacuum hose. Replace the vacuum hose if damaged.

-- Open the clamp on the vacuum hose with pliers.

-- Pull the vacuum hose off the brake system vacuum pump --.

-- Remove the brake system vacuum pump -- and bracket from the engine compartment.

-- Remove the brake system vacuum pump -- from the bracket.

-- Press the right and lift clips -arrow- out of the bracket by hand.

Fig 4: Identifying Brake System Vacuum Pump V192 Upward From Bracket
GWWN47-0234Courtesy of AUDI OF AMERICA, LLC

-- Remove the electrical vacuum pump upward while holding the rubber buffer securely.

Fig 5: Identifying Electrical Vacuum Pump Upward
GWWA47-10007Courtesy of AUDI OF AMERICA, LLC