Brake Booster Pressure Sensor -G294-: Removing
WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the plenum chamber cover, refer to PLENUM CHAMBER COVER, REMOVING AND INSTALLING .
NOTE:
The brake booster pressure sensor -- is located in the plenum chamber near the brake booster.
-- Disconnect electrical connector -1-.
-- Remove pressure sensor in -direction of arrow-.
NOTE:
The pressure sensor is secured with clips.
-- Release clips with pliers -1-.
-- Carefully pry the Brake Booster Pressure Sensor -- off.