Brake Caliper, Servicing, 1LA/1LJ
WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Install complete repair kit when servicing.
Apply thin coat of assembly paste G 052 150 A2 to brake cylinders, pistons and seals.
- Bolt
- 30 Nm
- Cap
- Insert in brake caliper.
- Replacing, refer to PROTECTIVE CAP AND GUIDE PIN, 1LA/1LJ .
- Guide Pins
- Slide through the boot.
- Replacing, refer to PROTECTIVE CAP AND GUIDE PIN, 1LA/1LJ .
- Cap
- Install on the bleeder valve.
- Bleeder Valve
- Apply a thin coat of assembly paste G 052 150 A2 to the threads before installing.
- 15 Nm
- Brake Caliper Housing
- Spring
- Ensure installation position is correct.
- Cap
- Do not damage when installing piston.
- Coat with Assembly Paste G 052 150 A2.
- Pistons
- First apply thin coat of brake cylinder paste G 052 150 A2 on piston.
- Diameter 57 mm.
- Seal
- Coat with assembly paste G 052 150 A2.
- Brake Carrier
- Removing and Installing, refer to FRONT BRAKE CALIPER WITH BRAKE CARRIER .
- The 4 retaining pins for the brake pads on the brake carrier must not be loosened under any circumstances.
- Bolt
- 196 Nm