LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2014 >> A5 Prestige >> Repair and Diagnosis >> External Pages >> Different car >> Section 87 (Mechanical Components - Brake System (Coupe)) >> 46 Mechanical Components >> Removal And Installation >> Rear Brakes >> Rear Brake Shield >> Installing

Rear Brake Shield: Installing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

-- Position the brake shield.

-- Install the bolts on the brake shield and tighten them.

-- Install the rear brake rotor, refer to REAR BRAKE ROTOR .

-- Install the brake hose and electrical wire into the bracket on the stub axle carrier.

NOTE:

Make sure the brake hose is correctly installed and secured inside the bracket on the stub axle carrier. So that the brake hose does not come out of the bracket on its own.

-- Mount the wheels.

Wheel bolt tightening specification, refer to WHEEL BOLT TIGHTENING SPECIFICATIONS .

-- Lower the vehicle.

scientia non olet · About LEMON Manuals