Front Brake Caliper, Replacing: Removing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Torque Wrench 40-200 Nm V.A.G 1332
Reversible Ratchet V.A.G. 1332/1
Torque Wrench 5-50 Nm V.A.G 1331
Reversible Ratchet V.A.G. 1331/1
Brake Pedal Actuator V.A.G 1869/2
Piston Resetting Tool T10145

-- Insert the V.A.G 1869/2 between the brake pedal and driver seat by pressing the brake pedal down at least 60 mm.

Fig 1: Identifying Brake Pedal Depressor VAG 1869/2 Inserted Between Brake Pedal And Driver's Seat

Courtesy of AUDI OF AMERICA, LLC

-- Raise the vehicle.

-- Remove the wheels.

-- Connect the hose from a bleeder bottle to one of the bleeder screws on the front caliper.

-- Open a bleeder screw on the front brake caliper to reduce the pressure from the brake system.

-- Close the bleeder screw.

NOTE:

Do not remove brake pedal loading device V.A.G 1869/2.

-- Remove brake pads, refer to BRAKE PADS .

NOTE:

When removing, mark brake pads that will be used again. Install in the same position, otherwise braking effect will be uneven!

A bolt secure the brake rotor.

-- Remove brake hose from brake caliper.

-- Remove the brake caliper from the vehicle.

-- Remove the bolts -5- on the brake carrier while holding the carrier securely.

Fig 2: Identifying Brake Caliper Components

Courtesy of AUDI OF AMERICA, LLC

-- Remove the brake carrier.