Front Brake Pads: Removing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

-- Raise the vehicle.

-- Remove the wheels.

NOTE:

When removing, mark brake pads that will be used again. Install in the same position, otherwise braking effect will be uneven!

-- Free up the brake hose on the bracket -4-.

Fig 1: Freeing Up Electrical Connector

Courtesy of AUDI OF AMERICA, LLC

-- Release the electrical wire from the bracket -2- toward the left -A- and remove.

WARNING:

The four retaining pins for the brake pads -9- in the brake caliper must not be loosened under any circumstances.

Fig 2: Identifying Brake System Components

Courtesy of AUDI OF AMERICA, LLC

-- Press the retaining spring -8- in the center.

NOTE:

The spring is tensioned, keep hands protected.

When removing the spring, make sure it does not scratch the brake caliper or damage the paint.

-- Remove the retaining spring carefully.

-- Disconnect the left front brake pad wear indicator connector.

NOTE:

Only the inner brake pad in the left front brake caliper has a brake pad wear indicator.

-- Loosen and remove both guide pin bolts -4- from the brake caliper.

Fig 3: Identifying Brake System Components

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

Never remove bolts -6 and 9-

-- Pull both guide pins out of the brake caliper slightly to make it easier to remove the caliper.

-- Remove the brake caliper.

NOTE:

Do not let the brake caliper hang from the brake hose. Secure it to the body with suitable cable ties or wire. Do not support the weight with the brake hose.

-- Remove brake pads from brake caliper housing or from brake carrier.

WARNING:

The four retaining pins for the brake pads in the brake caliper must not be loosened under any circumstances.