Brake Pedal, Automatic Transmission: Installing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Brake Pedal Assembly Overview

Courtesy of AUDI OF AMERICA, LLC

NOTE:

If possible, leave the brake pedal stop -17- installed; it could break the mount for the brake lamp sensor -10- if the brake pedal is released too quickly.

Be careful not to damage the stop -17- on the brake pedal. The brake lamp sensor mount -10- could break when the brake pedal is unlocked.

-- Slide the left retainer -12- onto the pins.

-- Slide the pins from left to right through the axle in the brake pedal.

-- Secure the pins with the right retainer -5-.

Fig 2: Identifying Brake Pedal Assembly Overview

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The pins must be secured with the securing clips -5 and 12- on both sides.

-- Install and tighten the bolt -11-.

NOTE:

Clip the brake pedal to the brake booster.

-- Hold the push rod ball head in front of the mount and push the brake pedal toward the brake booster, so that the ball head clicks into place.

-- Install the brake lamp sensor, refer to BRAKE LAMP SENSOR .

-- Install the footwell vents -A-B-.

Fig 3: Identifying Footwell Vents

Courtesy of AUDI OF AMERICA, LLC

-- Connect the connector -C- on the footwell vent.

-- Install the driver side instrument panel cover -1 to 3-.

Fig 4: Identifying Driver Side Storage Compartment

Courtesy of AUDI OF AMERICA, LLC