Brake Booster Plunger Mount: Installing
WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
-- Insert the brake booster mount and ball socket in the brake pedal.
The mount must engage audibly.
NOTE:
Clip the brake pedal to the brake booster.
-- Hold the push rod ball head in front of the mount and push the brake pedal toward the brake booster until the ball head engages audibly.
-- Install the brake lamp sensor, refer to BRAKE LAMP SENSOR .
-- Install the footwell vents -A-B-.
-- Connect the connector -C- on the footwell vent.
-- Install the driver side instrument panel cover -1 to 3-.