LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2014 >> A5 Prestige >> Repair and Diagnosis >> External Pages >> Different car >> Section 87 (Mechanical Components - Brake System (Coupe)) >> 46 Mechanical Components >> Description And Operation >> Rear Brakes With Electronic Parking Brake Overview

Rear Brakes With Electronic Parking Brake Overview

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Only install complete repair kit.

Rear wheel brake with automatic adjustment.

Fig 1: Identifying Rear Brake, Servicing Overview
GWWA46-10020Courtesy of AUDI OF AMERICA, LLC
  1. Self-Locking Bolt
    • 12 Nm
  2. Electromechanical Parking Brake Actuator
  3. Seal
    • Always replace.
  4. Self-Locking Bolt
    • 35 Nm
    • Always replace.
    • When loosening and tightening, counter-hold at guide pin.
  5. Spacer
  6. Brake Hose
    • To the brake caliper, 20 Nm.
    • Do not disconnect brake line when changing brake pads.
    • Make sure that retaining tabs are seated correctly in bracket.
    • Install hose without twisting.
  7. Brake Caliper Housing
  8. Brake Carrier with Guide Pins and Cap
    • Supplied as an assembled replacement part with sufficient grease on guide pins.
    • If protective caps or guide pins are damaged, install repair kit. Use grease packet supplied to lubricate guide pins.
    • It is possible to install brake carrier with brake caliper.
    • Removing and Installing, refer to REAR BRAKE CALIPER WITH BRAKE CARRIER .
  9. Brake Pads
    • Wear limit, refer to BRAKES PR CODES .
    • Must always be replaced together on both sides of axle.
    • Removing and Installing, refer to REAR BRAKE PADS .
    • Checking brake pad thickness
    • It is possible to install brake carrier with brake caliper.
      NOTE:

      The brake pads must be seated between both securing tabs on the pad retaining plate to provide the air gap between the brake rotor and brake pad.

  10. Brake Pad Retaining Plate
    • Always replace when pads are replaced.
      NOTE:

      The brake pads must be seated between both securing tabs on the pad retaining plate to provide the air gap between the brake rotor and brake pad.

  11. Wheel Bolts
  12. Bolt
    • 5 Nm
  13. Brake Rotor
  14. Hex Head Bolts
    • 10 Nm
  15. Brake Shield
  16. Bolt
    • 100 Nm + 90° turn
    • Replace
  17. Bolts
    • 100 Nm + 90° turn
    • Replace
scientia non olet · About LEMON Manuals