Removal And Installation

WARNING: This page is about a different car, the 2016 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The power window regulator motor must be initialized whenever the LF/RF (Navigator) or LF (Expedition) motor is removed from the vehicle. For additional information, refer to Window Motor Initialization .

1.

Remove the front door window glass. For additional information, refer to Window Glass - Front Door .

2.

Remove the inside glass weatherstrip.

GFD137700

Courtesy of FORD MOTOR COMPANY

3.

Remove the front door glass channel bolt and front door glass top run.
- To install, tighten to 11 Nm (97 lb-in).

GFD137701

Courtesy of FORD MOTOR COMPANY

4.

To install, reverse the removal procedure.
- The power window regulator motor must be initialized whenever the LF/RF (Navigator) or LF (Expedition) motor is removed from the vehicle. For additional information, refer to Window Motor Initialization .