LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2014 >> A5 Prestige >> Repair and Diagnosis >> External Pages >> Different car >> Section 796 (Wipers And Washers System) >> Removal And Installation >> Washer Pump - Expedition >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2016 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Carefully read cautionary information on product label. For emergency medical information seek medical advice. In the USA or Canada on Ford/Motorcraft products call the Poison Control Center at: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.
NOTE: When servicing the windshield washer pump, be careful not to damage the windshield washer pump seal.
NOTE: Do not operate the windshield washer pump before filling the windshield washer reservoir. Failure to do so may result in premature pump failure.

  1. 1.

    Remove the RH headlamp assembly. For additional information, refer to Exterior Lighting .

  1. 2.

    Position aside the shield as necessary to gain access to the washer pump.

  1. 3.

    Disconnect the windshield washer reservoir hoses.

  1. 4.

    Disconnect the windshield washer pump electrical connector.

  1. 5.

    Remove the windshield washer pump.

  1. 6.

    To install, reverse the removal procedure.