LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2014 >> A5 Prestige >> Repair and Diagnosis >> External Pages >> Different car >> Section 788 (Seating System) >> Diagnosis And Testing >> Seating >> Pinpoint Tests >> PINPOINT TEST BC : DTCs B106E, B106F >> PINPOINT TEST BC : DTCs B106E, B106F

PINPOINT TEST BC : DTCs B106E, B106F

WARNING: This page is about a different car, the 2016 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: If DTC B106F is present, the fault condition must be corrected prior to installing a new DSM. Failure to correct the fault condition first may cause damage to the new DSM, resulting in a repeat repair.

  1. BC1 REVIEW THE DTCs

    • Review the DTCs from the DSM self-test.

    Are DTCs B106F and B1342 present? 

    Yes  CORRECT the cause of any other DTCs present. When the other DTCs are corrected, INSTALL a new DSM. REFER to Driver Seat Module (DSM) . TEST the system for normal operation.
    No  GO to  BC2.

  2. BC2 REPAIR OTHER DTCs

    • Repair the cause of any DTCs present, other than DTC B106E. Refer to DTC Charts .
    • Clear the DTCs.
    • Carry out the DSM self-test.

    Is DTC B106E still present? 

    Yes  The fault causing the output state to be disabled is still present. REPAIR the cause of the concern. CLEAR the DTCs. REPEAT the self-test.
    No  The system is operating correctly at this time. The concern was caused by a fault in one of the output circuits.
scientia non olet · About LEMON Manuals