Transmission Range Gear Recognition Switch -F208-, Transmission Installed: Installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2013 Audi S5, 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, and 2009 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

-- Install the transmission range gear recognition switch in the selector shaft cover. Tightening specification Tightening Specification .

-- Connect the connector -2- to the transmission range gear recognition switch.

Fig 1: Identifying Bolts For Selector Rod And Push Rod

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Ignore -1- and -3-.

-- Tighten the tunnel crossmember bolts -arrows-. Tightening specification TUNNEL CROSSMEMBER, TRANSMISSION MOUNT AND TRANSMISSION SUPPORT OVERVIEW .

Fig 2: Identifying Bolts & Tunnel Crossmember

Courtesy of AUDI OF AMERICA, LLC

-- Re-assemble the exhaust system and ensure it is not under stress. Refer to EXHAUST SYSTEM, EMISSION CONTROLS .

-- Install the rear noise insulation. Refer to NOISE INSULATION .