Transmission Range Gear Recognition Switch -F208-: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2016 Audi S5, 2015 Audi S5, 2014 Audi S5, 2013 Audi A5, and 2012 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

-- Install the transmission range gear recognition switch -- in the selector shaft cover. Tightening specification Transmission Range Gear Recognition Switch -F208- .

Fig 1: Installing Connector On Transmission Range Gear Recognition Switch

Courtesy of AUDI OF AMERICA, LLC

-- Install the connector -2- on the transmission range gear recognition switch --.

NOTE:

Disregard -1 and 3-.

-- Install the tunnel crossmember -arrows- -2- 2.

Fig 2: Identifying Bolts & Tunnel Crossmember

Courtesy of AUDI OF AMERICA, LLC

-- Re-assemble the exhaust system and ensure it is not under stress. Refer to the appropriate service information .

-- Install the noise insulation. Refer to OVERVIEW - NOISE INSULATION .

Tightening Specification

Component	Nm
Transmission range gear recognition switch -F208-	20