Transmission Neutral Position Sensor -G701-: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2016 Audi S5, 2015 Audi S5, 2014 Audi S5, 2013 Audi A5, and 2012 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Noise Insulation Components

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the fasteners -2 and 3- and remove the rear noise insulation.

-- Move gearshift lever -2- forward in direction of -arrow- and shift into 4th gear.

Fig 2: Identifying Gearshift Assembly

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Ignore -1-.

-- Disconnect the connector from the transmission neutral position sensor -G701- -1-.

Fig 3: Identifying Connector To Transmission Neutral Position Sensor

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -arrow- and remove the transmission neutral position sensor -- -A-.

Fig 4: Identifying Bolt -Arrow- And Remove Transmission Neutral Position Sensor -A-

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The cover -B- remains installed.