Transmission Neutral Position Sensor -G701-: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2016 Audi S5, 2015 Audi S5, 2014 Audi S5, 2013 Audi A5, and 2012 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.

-- Install the transmission neutral position sensor -- -A- with a new O-ring in the gearshift shaft cover -B-.

-- Tighten the new bolt -arrow- to the tightening specification Transmission Neutral Position Sensor -G701- .

-- Connect the connector to the transmission neutral position sensor -- -1-.

Fig 1: Identifying Connector To Transmission Neutral Position Sensor

Courtesy of AUDI OF AMERICA, LLC

-- Install the noise insulation. Refer to OVERVIEW - NOISE INSULATION .

Tightening Specification

Component	Nm
Transmission Neutral Position Sensor -G701-	10 + 45°
Replace the bolt.