Selector Shaft Seal: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2016 Audi S5, 2015 Audi S5, 2014 Audi S5, 2013 Audi A5, and 2012 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Gearshift Shaft Seal, Removing And Installing

Courtesy of AUDI OF AMERICA, LLC

-- Lightly coat the outer circumference of the seal with oil.

-- Fill the space between the sealing and dust lip half way with sealing grease G 052 128 A1.

-- Install the shaft seal with T10001/1.

Installed dimension: 2 mm below the outer edge of the housing

-- Install the selector lever as follows:

Fig 2: Gearshift Lever Can Be Attached To The Gearshift Shaft In Only One Position

Courtesy of AUDI OF AMERICA, LLC

The gearshift lever -2- can be attached to the gearshift shaft -1- in only one position (gap in the splines -arrow-).

-- Tighten the selector lever. Tightening specification -item 18- 18.

-- Install the noise insulation. Refer to OVERVIEW - NOISE INSULATION .