Selector Mechanism: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2016 Audi S5, 2015 Audi S5, 2014 Audi S5, 2013 Audi A5, and 2012 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

Tightening specifications, refer to SELECTOR MECHANISM OVERVIEW and GEARSHIFT KNOB WITH GEARSHIFT LEVER BOOT OVERVIEW .

NOTE:

Seals and self-locking nuts must be replaced.

-- Install the tunnel crossmember. Refer to TUNNEL CROSSMEMBER .

-- Install the heat shield under the shift mechanism. Refer to UNDERBODY TRIM PANEL .

-- Secure the driveshaft on the transmission. Refer to Removal and Installation (0BC) or Removal and Installation (0BD) .

-- Reconnect exhaust system making sure it is not under stress. Refer to the appropriate service information .

-- Install the noise insulation. Refer to OVERVIEW - NOISE INSULATION .

-- Install the gearshift mechanism. Refer to SELECTOR MECHANISM, ADJUSTING .

-- Install the multimedia system control head --. Refer to MULTIMEDIA SYSTEM CONTROL HEAD -E380-, REMOVING AND INSTALLING .

-- Install the A/C system control head. Refer to DISPLAY AND CONTROL HEAD, REMOVING AND INSTALLING .