Gear Recognition Sensor: Installing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2016 Audi S5, 2015 Audi S5, 2014 Audi S5, 2013 Audi A5, and 2012 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
-- Replace the O-rings -4-.
CAUTION:
There is a risk of breaking or causing malfunctions in the gear recognition sensor -- during installation.
- The gear recognition sensor -- -3- may not be stamped on or imbedded with a bolt -1- into the transmission.
- The O-rings -4- and the opening in the transmission cover must be lubricated with transmission fluid.
- The gear recognition sensor -- -3- may be pressed lightly on using an aid for example the shaft of a hammer.
-- Secure the gear recognition sensor -- with the bolt -1-. Tightening specification GEAR RECOGNITION SENSOR
-- Connect the connector -2-.
-- Install the tunnel crossmember -arrows-, tightening specifications -2- 2.
-- Re-assemble the exhaust system and ensure it is not under stress. Refer to the appropriate service information .
-- Install the noise insulation OVERVIEW - NOISE INSULATION .
Tightening Specification
| Component | Nm |
|---|---|
| Transmission range gear recognition switch -F208- | 10 Nm +45° |