MECHATRONIC Unit: Installing

• Tightening specifications, refer to ATF PAN, ATF STRAINER AND MECHATRONIC OVERVIEW .

-- Make sure the seal -B- is installed correctly and is secure.

Fig 1: Identifying Oil Seal For ATF Strainer From Transmission, Removal/Installation

Courtesy of AUDI OF AMERICA, LLC

-- Set Mechatronic unit in place without using force, and at the same time insert stud on the selector lever -arrow- into the groove on the selector slide -A- ; if necessary, move selector slide back or forth.

Fig 2: Inserting Transmission Selector Lever Stud Into Groove On Selector Slide

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the bolts -1- and -2- on the Mechatronic to 2 Nm.

Fig 3: Identifying Bolt Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the bolts on the Mechatronic to the tightening specification and in the given sequence, that is, first bolt -1-, then -2- through -14-.

-- Attach the wiring harness -A- to the Mechatronic. At the same time, insert the tab -arrow- on the back of the wiring harness into the Mechatronic unit.

Fig 4: Identifying Mechatronic Wire Harness Components, Removal/Installation

Courtesy of AUDI OF AMERICA, LLC

-- Remove both locking mechanisms -1 and 2- on the connector -C- as illustrated, if applicable.

-- Carefully insert the connector -C- into the Mechatronic connector socket.

-- Press both locking mechanisms -1 and 2- in on the connector -C- to secure it, if applicable.

Fig 5: Identifying Locking Mechanism

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal paying attention to the following:

-- Install the ATF strainer. Refer to ATF STRAINER .

-- Install the ATF pan. Refer to AUTOMATIC TRANSMISSION FLUID OIL PAN .

-- Fill the ATF. Refer to ATF, DRAINING OR FILLING AFTER REPAIR .