Overview - Drive Plate
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For assembly work, secure the engine on the Engine And Transmission Holder VAS6095, refer to ENGINE, SECURING ON ENGINE AND TRANSMISSION HOLDER .
- Drive Plate
- With the bearing flange
- Check the running surfaces on the bearing flange and the clutch module holes for cracks and signs of wear.
- Removing and installing, refer to DRIVE PLATE, REMOVING AND INSTALLING .
- Bolt
- 60 Nm +90°
- Replace
- Not Installed
- Sensor Wheel
- For Engine Speed Sensor -G28-
- Crankshaft
- Alignment Pin
- Shaft Seal
- For the crankshaft on the transmission side
- Replacing, refer to CRANKSHAFT SEAL, REPLACING, TRANSMISSION SIDE .