Drive Plate, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
- The transmission is removed, refer to TRANSMISSION, REMOVING AND INSTALLING .
-- Insert the Counterhold - Flywheel 10-201 to loosen the bolts.
CAUTION:
The outer surface of the bearing flange at the drive plate could be damaged.
- Use a multipoint socket wrench with a shaft at least 40 mm long to loosen and tighten the drive plate bolts.
-- Remove the bolts, drive plate and sensor wheel.