Brakes Inspection, Electromechanical Parking Brake

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Test Sequence:

-- Drive the vehicle with the rear wheel on the test rollers

Do not Switch off the Ignition

-- As soon as the rollers reach a speed between 3 km/h and 9 km/h, "T U V mode" is activated.

"Parking brake in diagnostic mode" appears in the instrument cluster when T U V mode is activated.

The "parking brake" display in the instrument cluster will start to blink

The EPB Functions as Follows:

The brakes do not close once, but rather close a bit each time the button is pressed.

The tension is sufficient for measuring after a few steps.

Pay attention the display in the brake test stand.

One press on the button releases the brakes again.

Prerequisite for "T U V Mode" :

-- Ignition on

-- Front wheels, speed greater = 0 km/h

-- Rear wheels, speed min. = 3, max. 9 km/h.

"Parking brake in diagnostic mode" appears in the instrument cluster when T U V mode is activated.

The "parking brake" display in the instrument cluster will start to blink

WARNING:

A brake test stand with a regulated wheel set must be used on vehicles with all wheel drive.