Door Gap Cover, Removing And Installing
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- The adhesive surfaces on the body must be free of dirt and grease.
- Clean the adhesive surfaces using Cleaning Solution D 009 401 04.
- Warm the adhesive surfaces to approximately 40 °C (104 °F) using a hot air blower.
- After installing, take the roller and press the covers one more time.
-- Unclip the upper door gap cover -1- starting from the back toward the front and then pull it off the door flange.
-- Remove any remaining adhesive from the surface.
-- Peel off the protective film from the two-sided adhesive tape.
-- Position the cover on the door flange from underneath, align it so that it centered and then push it into the clips -2-.
-- Removing and installing is same as on the front door.