Flange And Driveshaft Seals, Rear Final Drive Removed: Notes
WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2016 Audi S5, 2015 Audi S5, 2015 Audi RS 5, and 2014 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
- It is necessary to install the old flange/driveshaft.
- If the flange/driveshaft is also being removed. Refer to FLANGE/DRIVESHAFT AND SEAL WITH REAR FINAL DRIVE REMOVED .
Special tools and workshop equipment required
- Puller VW 391
- Slide Hammer - Complete Set VW 771
- Pulling hook VW 771/37
- Thrust Piece T40112
- Retainer 3028
- Seal Driver-Frt Wheel Bearing 3143
- Adapter T10235
- Friction Meter VAS 6222
- Inductive Heat Unit VAS 6414
- Sealing grease G 052 128 A1
- Locking fluid AMV 185 101 A1
- Three M8 x 25 bolts
- 2 bolts M10 x 40