Driveshaft To Transmission: Installing
WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2016 Audi S5, 2015 Audi S5, 2015 Audi RS 5, and 2014 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
Installation is in the reverse order of removal. Observe the following when doing so:
- Remove any old or dried-up high temperature grease from the CV joint and the driveshaft flange. Fill with the exact same amount of high temperature grease G 000 633.
- Threaded holes in flange shaft on the transmission must be cleaned of locking compound residue. Use a thread cutter to clean the holes. Otherwise the bolts could break off when being installed.
- Always replace (self-locking) securing bolts for driveshaft.
-- Check the driveshaft seal on the transmission flange for damage and replace if necessary.
-- Install the driveshaft and install the CV joint bolts.
-- Tighten the front bolts on the driveshaft. Tightening specification -5- DRIVESHAFT BOLTED ON TRANSMISSION-SIDE ASSEMBLY OVERVIEW .
- Use the T10172 with the T10172/5.
-- Attach the heat shield -A- (if equipped) to the transmission -arrows-. Tightening specification DRIVESHAFT BOLTED ON TRANSMISSION-SIDE ASSEMBLY OVERVIEW .
-- Assemble the exhaust system and then align it free of tension. Refer to the appropriate service information .