Diagnostic Mode 09 - Read Vehicle Information

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2017 Audi S5, 2016 Audi S5, 2016 Audi S4, 2015 Audi S5, and 2015 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

Diagnostic Mode 09 makes it possible to access vehicle-specific information from the ECM and the TCM (where applicable).

NOTE:

Depending on scan tool and protocol used, Diagnostic Mode 09 and the information provided may be referred to by a different name.

Test requirement

No DTCs stored in the DTC memory.

Procedure

-- Connect the scan tool.

-- Switch the ignition on.

-- Select Mode 09: Vehicle information.

-- Select the desired Test-ID.

-- The information requested will be displayed on the scan tool screen.

The following table is a numerical list of all Test-IDs that may be selected.

Test-ID	Diagnostic text
02:	Vehicle identification number (VIN) e.g.
	A different 17 digit number will be displayed for each vehicle
04:	Calibration identification (CALID) e.g.
	Calibration Identification (CALID) Part number and software version
06:	Calibration verification number (CVN) check sum e.g.
	EC5AE460 the check sum is different for every control module version
	000D105
0A:	ECM / TCM Name e.g.
	Engine Control Module -J623-
	Transmission Control Module -J217-
08:	In-Use Performance Tracking (IPT - Counter)
	General Denominator: OBDCOND Ignition Cycle Counter: IGNCNTR Function-specific numerators / denominators Catalyst diagnosis O2S probe diagnosis before catalytic converter EGR diagnostic / Camshaft Position - diagnosis Secondary air injection diagnostics EVAP diagnosis O2S probe after catalytic converter diagnosis

-- Switch the ignition off.