Driveshaft, Removing From Rear Final Drive: Installing
WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2017 Audi S5, 2016 Audi S5, 2015 Audi S5, 2014 Audi S5, and 2013 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Pay attention to the following:
- Remove the old, dry high-temperature grease from the CV joint and the driveshaft flange. Fill with the exact same amount of new high temperature grease G 000 633.
- The threads in the flange shaft on the rear final drive must be cleaned of locking fluid residue. Use a thread tap to clean the threads. If the threads are not clean, the bolts will break off when they are being installed.
- After removing the driveshaft from the rear final drive, do not install the additional balance washer (thicker washer) that may be between the lock plate and bolt.
- Always replace securing bolts for driveshaft (self-locking bolts).
- Check the driveshaft seal on the rear final drive flange for damage (bent, rubber layer worn off) and replace if damaged. Replace the damaged seal.
-- Position the driveshaft on the rear final drive:
- The dots on the driveshaft -arrow A- and on the rear final drive -arrow B- must line up.
- Maximum difference between the markings: 30°.
-- Insert and tighten the new bolts -1- for the driveshaft. Follow the tightening sequence, refer to Figure.
-- Install the rear section of the exhaust system. Refer to the appropriate service information .