Right Engine Mount, Removing And Installing: Removing

Fig 1: Mount 10 - 222 A With T40093/6 On Left And Right Suspension Strut Towers (As Illustrated)

Courtesy of AUDI OF AMERICA, LLC

-- Install the Engine Support Bridge10-222A with the Engine Support - Supplement Kit Adapter 6 T40093/6 on the left and right suspension strut tower, as shown in the illustration.

-- Engage the Engine Support Bridge - Spindle10-222A/11 in the left and right engine lifting eyes.

-- Lightly pretension engine with spindles.

-- Remove the right front wheel.

Fig 2: Noise Insulation Panels

Courtesy of AUDI OF AMERICA, LLC

-- Remove the right front wheel housing liner. Refer to WHEEL HOUSING LINER .

-- Remove the noise insulation -1 and 2-. Refer to NOISE INSULATION, REMOVING AND INSTALLING .

-- Remove and disconnect the connector -2- on the Right Electrohydraulic Engine Mount Solenoid Valve -N145- from the bracket.

Fig 3: Locating Nut On Electrical Wiring Bracket

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nut -1- and remove the bracket with the wiring harness from the subframe.

-- Remove the bolts -1, 2 and 4- and move the right engine mount retaining plate -3- to the side.

Fig 4: Identifying Bolts And Right Engine Mount Retaining Plate

Courtesy of AUDI OF AMERICA, LLC

Vehicles with S tronic Transmission 0B5 

Fig 5: Identifying ATF Line Bracket

Courtesy of AUDI OF AMERICA, LLC

-- Remove bolt -arrow- on ATF line bracket.

Continuation for All Vehicles 

Fig 6: Identifying Special Tool - 10 - 222 A /11

Courtesy of AUDI OF AMERICA, LLC

-- Lift the engine using the right Engine Support Bridge - Spindle10-222A/11 -1- to dimension -a-.

• Dimension -a- = approximately 20 mm.

-- Remove the right engine mount.