Overview - SUBFRAME Mount

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2017 Audi S5, 2016 Audi S5, 2016 Audi S4, 2015 Audi S5, and 2015 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Subframe Mount Assembly Overview

Courtesy of AUDI OF AMERICA, LLC

Bolt
- 20 Nm
Retaining Plate
- For the engine mount
- If the engine mount is faulty, replace the retaining plate
- Check the retaining plate on the opposite side; replace if necessary.
Bolt
- 40 Nm
Engine Support
Bolt
- 10 Nm
Heat Shield
Bolt
- 90 Nm +90° turn
- Replace
Engine Mount
- Removing and installing. Refer to LEFT ENGINE MOUNT, REMOVING AND INSTALLING for left side and RIGHT ENGINE MOUNT, REMOVING AND INSTALLING for right side.
- Replace in pairs
Subframe
Bolt
- 55 Nm

Fig 2: Identifying Hydraulic Oil Hose Bracket & Nut

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the nut -2- for the hydraulic fluid hose bracket -1- to 9 Nm.