Overview - Rear Outer Three-Point Seat Belt
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The illustration shows a three-point seat belt in a sedan.
- Bolts
- Do not change the bolt position when removing and installing the belt guide. It is set by the manufacturer.
- Rear Outside Belt Guide
- Replace the entire belt guide if damaged.
- Removal and installation: sedan REAR SEAT BELT GUIDE, REMOVING AND INSTALLING, SEDAN ; Avant OUTER REAR BELT GUIDE, REMOVING AND INSTALLING, AVANT
- Bolt
- 45 Nm
- If it was removed because of an accident, replace the bolt
- Nut
- Automatic Belt Retractor
- Depending on the market version with Driver Side Rear Seat Belt Tensioner Igniter -N196-
- Depending on the market version with Passenger Side Rear Seat Belt Tensioner Igniter -N197-
- Removal and installation: for sedan refer to REAR THREE-POINT SEAT BELT, REMOVING AND INSTALLING, SEDAN ; for Avant refer to REAR THREE-POINT SEAT BELT, REMOVING AND INSTALLING, AVANT .
- Noise Insulation
- For the automatic belt retractor
- Connector
- Depending on the market version for Driver Side Rear Seat Belt Tensioner Igniter -N196-
- Depending on the market version for Passenger Side Rear Seat Belt Tensioner Igniter -N197-
- Bolt
- 45 Nm
- If it was removed because of an accident, replace the bolt
- Outer Rear Belt End Fitting
- Removing and installing. Refer to REAR OUTER BELT END FITTING, REMOVING AND INSTALLING .