Overview - Head Curtain Airbag, AVANT
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Head Curtain Airbag
- Driver side: with Driver Head Curtain Airbag Igniter -N251-
- Passenger side: with Front Passenger Head Curtain Airbag Igniter -N252-WARNING:
Follow all Safety Precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS .
- Removing and installing. Refer to HEAD CURTAIN AIRBAG WITH IGNITER, REMOVING AND INSTALLING, AVANT .
- Nut
- 9 Nm
- On ground bolt
- Nut
- 9 Nm
- On ground bolt
- Two ground cables have also been bolted into place on the right side of the vehicle
- Connector
- For Driver Head Curtain Airbag Igniter -N251- /Front Passenger Head Curtain Airbag Igniter -N252-
- Disconnecting and connecting, refer to REMOVING .
- Retaining clip
- Removing and installing. Refer to REMOVING -> Disengage the side curtain airbag retaining tab clips -1- from the body by pressing the locking mechanisms together -arrows- using needle nose pliers or o-ring pliers .
- Clip
- Quantity 1 or 2 depending on the version
- Replace
- With a factory installed mount with 1 clip and double adhesive tape, use 2 clips for re-installing.
- Bolt
- 3.5 Nm
- Self-locking
- Always replace if removed
- Threaded holes for screws must always be cleaned, for example, with thread cutter