Head Curtain Airbag With Igniter, Removing And Installing, Sedan: Removing
-- Move the seats all the way forward and adjust the backrest to a 45° angle.
- Follow all Safety Precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS .
- Follow all regulations when disposing of pyrotechnic components. Refer to AIRBAG, BELT TENSIONER AND BATTERY CUT-OUT UNITS, STORING, TRANSPORTING AND DISPOSING .
-- Turn on the ignition.
-- Disconnect the battery ground cable with the ignition turned on. Refer to BATTERY, DISCONNECTING AND CONNECTING .
-- Remove the headliner and lay it on the seats, do not remove the windshield. Refer to HEADLINER, REMOVING AND INSTALLING, SEDAN .
-- Remove the clip -2- and, where applicable -1-.
-- Remove head curtain airbag bolt -3- on the A-pillar.
Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.
-- Disconnect the connector -4-.
-- Release the connector lock -3- using a small screwdriver -1- and disconnect the connector -2- from the gas generator .
-- Remove cap nuts -1- and -2-.
-- Disengage the side curtain airbag retaining tab clips -1- from the body by pressing the locking mechanisms together -arrows- using needle nose pliers or o-ring pliers .
-- Remove head curtain airbag from vehicle.