Driver Side Airbag, Assembly Overview, Attached Airbag Version
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Locking Bracket
- Use a T25 TORX screwdriver, approximately 100 mm long
- Steering Column Electronics Control Module -J527-
- With Airbag Spiral Spring/Return Spring with Slip Ring -F138- and Steering Angle Sensor -G85-
- Removing and Installing. Refer to SENSORS
- 4-Spoke Steering Wheel
- Equipment levels
- Removing and Installing. Refer to STEERING WHEEL, REMOVING AND INSTALLING .
- Wiring Harness
- For the Driver Airbag Igniter -N95- and Driver Airbag Igniter 2 -N250-
- Replacing. Refer to AIRBAG CONNECTOR, REPLACING .
- Press in to secure in the pockets on the steering wheel.
- Driver Side Airbag
- With Driver Airbag Igniter -N95- and Driver Airbag Igniter 2 -N250-WARNING:
Follow all Safety Precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS .
- Removing and installing. Refer to AIRBAG UNIT WITH IGNITER, REMOVING AND INSTALLING .
- With Driver Airbag Igniter -N95- and Driver Airbag Igniter 2 -N250-
- Bolt
- Tightening specification:
- 30 Nm +90°
- Always replace if removed
- Tightening specification:
- 3-Spoke-Steering Wheel
- Equipment levels
- Removing and Installing. Refer to STEERING WHEEL, REMOVING AND INSTALLING .
- Wiring Harness
- For the Driver Airbag Igniter -N95- and Driver Airbag Igniter 2 -N250-
- Replacing. Refer to AIRBAG CONNECTOR, REPLACING .
- Press in to secure in the pockets on the steering wheel.
- Driver Side Airbag
- With Driver Airbag Igniter -N95- and Driver Airbag Igniter 2 -N250-WARNING:
Follow all Safety Precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS .
- Removing and installing. Refer to AIRBAG UNIT WITH IGNITER, REMOVING AND INSTALLING .
- With Driver Airbag Igniter -N95- and Driver Airbag Igniter 2 -N250-
- Bolt
- Tightening specification.
- 30 Nm +90°
- Always replace if removed
- Tightening specification.