Airbag Connector, Replacing, Bolted Airbag Version: Installing
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
- Follow all Safety Precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS .
- Before handling pyrotechnic components (for example, connecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.
Install in reverse order of removal. Note the following:
NOTE:
Make sure the connectors are installed correctly and are secure.
WARNING:
- Follow all Safety Precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS .
- Before handling pyrotechnic components (for example, connecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.
-- Connect the connector -1- to the airbag igniter -arrow A-.
-- Install the connector locking mechanism -2- -arrow B-. While doing this, the connector is pushed into the airbag igniter and locks into place.
Installation is performed in reverse order of removal, while noting the following:
NOTE:
Make sure the connectors are installed correctly and are secure.