Backrest Heating Element -Z7- / -Z9-, Removing And Installing, Standard Seat: Installing
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Align the new backrest heating element on the padding.
CAUTION:
- Make sure the new backrest heating element is affixed to the old heating element.
- Remove the protective films in the bonding sequence for the heating element area.
- When removing the protective film, make sure the heating element is not damaged and that it is attached without wrinkles.
-- Bond the individual areas of the heating element in the sequence -A, B and C-.
-- Route the connecting wires to the individual heating surfaces in the base of the gaps -arrow-.
-- Pull the wire -3- through the slit in the padding -1-.
Install in reverse order of removal.