LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2014 >> A5 Prestige >> Repair and Diagnosis >> External Pages >> Different car >> Section 604 (3.0L - Cooling System - Engine Code(S): CCBA, CGXC & CTUB (Sedan)) >> 19 Cooling System >> Coolant Pump/Thermostat >> Electric Coolant Pump, Removing And Installing >> Charge Air Cooling Pump -V188-, REMOVING AND INSTALLING >> Installing

Charge Air Cooling Pump -V188-, REMOVING AND INSTALLING: Installing

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2017 Audi S5, 2016 Audi S5, 2016 Audi S4, 2015 Audi S5, and 2015 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Secure all hose connections with hose clamps of the same type as those equipped by the factory.

-- Tighten the nut the charge air cooling pump bracket. Refer to Figure.

-- Install the front wheel housing liner. Refer to FRONT WHEEL HOUSING LINER, REMOVING AND INSTALLING .

-- Install the front wheel. Refer to WHEEL BOLT TIGHTENING SPECIFICATIONS .

-- Fill with coolant. Refer to FILLING .

scientia non olet · About LEMON Manuals